The roof surface of the Fiat Ducato panel van is profiled in the longitudinal direction, so it is not easy to stick on the solar mounting profiles and the Flat Light solar modules. There is not enough adhesive surface available in the front area and there is also a risk of wind noise. Special "bead fillers" are available for this purpose. These are glued into the recesses with Sikaflex (included with every complete system) and the bracket or Flat Light solar module is then glued onto the continuous surface. This is not necessary or advisable in the rear area so that water can run off without any problems.
Bead filler set consisting of two specially pre-treated aluminum plates. Depending on the module width and positioning, different numbers of plates are required.
Ultra-flat
roof duct
Ultra-flat
roof duct
Central connection
downwards possible!
Hall sensor with connection cable